This ready to use silicone mould is great for creating a resin candle holder. These moulds are great for Epoxy and UV resin casting. No release agent is required. Keep away from abrasive materials to avoid scratching the silicone. Mould may be washed with warm, soapy water.
Measurement: approx. 5.7cm (Diameter) x 4.4cm (H) / 2.24″ (Diameter) x 1.73″ (H)
Previous product
Back to products
SC94 Single Component Coating
From $172.50
Next product
Hamsa Palm DishSilicone Mould
$23.00 (inc. gst) $13.80 (inc. gst)
Silicone Mould Candle Holder 57x44mm
$26.45 (inc. gst)
Available at:
Auckland
Description
Related products
Liquid Latex
***ALSO REFERRED TO AS DIP OR SPRAY LATEX***
Woven Bangle Mould
MLD-B1
Surface Tissue
Surface tissue is used in the inner corrosion barrier to form a resin-rich layer, and also in the exterior layer
Measuring Cup 60ml
These 60ml measuring cups can be used to measure small volumes of resin, silicone catalyst, or for decanting small volumes
Small Carved Bangle Mould
MLD-B15
Forton MG
Forton MG (Forton Modified Gypsum) is a system whereby a polymer additive (Forton VF812) enhances the properties of the alpha
Brush Latex
***PLEASE DO NOT USE THIS FOR DIPPING – THIS IS A THICKENED FORMULA FOR BRUSHING***
Geltex Latex Thickener
Geltex Latex Thickener is used in latex moulding rubbers. Add up to 2% and shear mix until the desired consistency
